Move-and-level support for technical equipment

01

The challenge

Some technical equipment must move for installation or service but should not remain supported only by wheels during operation.

02

Operating conditions

Define equipment mass, centre of gravity, floor level variation, adjustment access and the frequency of relocation.

03

Caster selection factors

• Confirm both rolling capacity and support-foot capacity.
• Check available adjustment stroke and mounting height.
• Keep adjustment controls accessible after installation.

04

Recommended configuration path

Select plate or threaded-stem mounting from the equipment interface, then compare wheel size, support capacity and adjustment geometry.

05

Engineering notes

Levelling performance and stability require complete-equipment verification. This content does not replace structural or safety assessment.